The electric rail handling carts operator must be familiar with the structural performance of the equipment, and can obtain independent operation after passing the test. The operator must conscientiously do "three good" (management, use, repair), "four meetings" (will use, will maintain, will check, will eliminate the fault). The operator must comply with the “five disciplines” of the equipment and the “four requirements” of the maintenance equipment. The operator should check the equipment at any time in accordance with the requirements of the “tour inspection content”.
Strictly follow the equipment lubrication chart to refuel, to achieve "five" (timed, fixed point, quantitative, qualitative, fixed), after the oil should be covered with the lid of the oil cup (pool).
Super-standard and overloaded equipment is strictly prohibited. When transporting heavy objects, it must be placed smoothly and gently to ensure uniform weight distribution. Before starting the equipment, you must first send a signal to see if there is no movement direction, no obstacles can be activated, and the start and stop are not allowed to collide with the end stop. When the start switch cannot be moved, it should be checked immediately to prevent the motor from being burnt or other accidents.
When changing the direction of motion, it must be stopped after the motion has completely stopped. Always check the operation of each department. If the motor or bearing temperature rises or abnormal sound is found, stop it immediately. Do not drive the Electric rail handling carts to the top, hit, tow, or pull the vehicle on the railway. The forward and backward directions are obvious, and the switch is reversed and consistent. It is strictly forbidden for the operator to leave or trust the electric rail handling carts in operation.
For battery rail handling carts, when the battery is low, the battery should be taken out and charged as required, and replaced with a spare battery for work. The replacement and charging of the battery should be handled by a special person. Before leaving work, you must remove the load and cut off the power supply, and clean it according to the system.
Electric rail handling carts tour inspection content. Travel mechanism: The motor, coupling, reducer (reduction gear) are not loose and operate normally. The reducer (reduction gear) has sufficient oil, the oil quality meets the requirements, and there is no dust and debris. The brake is sensitive and easy to use, and the brake wheel is in contact with it without serious wear. The wheels are in proper contact and rotate well. Body part: The car body is not deformed, the car platform is flat and there is no squat pit, and the whole car is neat and tidy. Electrical part: The sliding wire is in good contact with the slider (cable), the movement is flexible, and the wire frame is firmly intact (or the battery is fully charged). The electrical switch is sensitive and easy to use. The bell sound is loud. All electrical appliances are well insulated. Other parts: The maintenance information is complete and clean. The equipment is complete.
